Note:
The groove on the end face of the model is cleaned, and the actual finished product shape after processing is R0.1~0.5.
Note:
The purpose of the center hole on the end face is to prevent eccentricity when turning the part.
You can select [Do not allow center hole], but the shape that can be processed may be restricted and cannot be processed. In this case, please confirm the [Notes] on the upper left of the screen.
Points to note about the bottom of the hole (turning and milling)
The most appropriate processing method is automatically determined based on the hole characteristics and tolerances. Therefore, some blind holes may have a flat bottom, but the finished product may have a conical bottom (118°), and vice versa.
